For Your Safety - Festo EduTrainer 574177 Descripción

Brief description
®
KNX louvre EduTrainer –

4 For your safety

Malfunctions which may impair safety must be eliminated immediately!
General

Trainees may only work with the circuits under the supervision of a trainer.

Electrical devices (e.g. power supply units, compressors and hydraulic power units) may only be
operated in training rooms which are equipped with residual current devices (RCDs).

Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!

Malfunctions which may impair safety must not be generated in the training environment, and must be
eliminated immediately.

Wear personal protective equipment (safety goggles, safety shoes) when working on circuits.
Electrical components

Disconnect from all sources of electrical power!
– Switch off the power supply before working on the circuit.
– Please note that electrical energy may be stored in individual components.
Further information on this issue is available in the data sheets and operating
instructions included with the respective components.

Use extra-low voltage only: max. 24 V DC.

Establishing and disconnecting electrical connections
– Electrical connections may only be established in the absence of voltage.
– Electrical connections may only be disconnected in the absence of voltage.

Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the cable and the fuse.
– In the event that these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.

Use only connecting cables with safety plugs for electrical connections.

When laying connecting cables, make sure they are not kinked or pinched.

Do not lay cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.

Make sure that connecting cables are not subjected to continuous tensile loads.
14
© Festo Didactic 8024281