Phottix Indra500 TTL Manual De Instrucciones página 3

External Power Port
The Indra500 TTL Studio Light can be connected to the Phottix Indra AC Adapt-
er or the Phottix Indra Battery Pack through the external power port.
Please note:
When connecting the external power source, only use Phottix flash power
cords designed for use with the Indra500 TTL Studio Light.
Connecting the Indra500 to the external power
source
Using the Phottix Indra Battery Pack
1. Insert one end of the included flash power cord into the external power port
on the Indra500 TTL Studio Light. (See picture 1)
Note:
To insert properly, please align the red dots on the cable and port.
2. Insert the other end into the output port on the Phottix Indra Battery Pack.
(See picture 2)
3. Turn on the Output Toggle Switch on the Battery Pack.
4. Turn on the power switch on the Phottix Indra500 TTL Studio Light.
Using the Phottix Indra AC Adapter
1. Insert one end of the included flash power cord into the external power port
on the Indra500 TTL Studio Light. (See picture 1)
Note:
To insert properly, please align the red dots on the cable and port.
2. Insert the other end into the output port on the Phottix Indra AC Adapter.
(See picture 3)
3
INSTRUCTION MANUAL
En
3. Connect the AC Adapter to the mains supply.
4. Turn on the main power switch and the output power switch on the AC Adapter.
5. Turn on the power switch on the Phottix Indra500 TTL Studio Light.
Disconnecting the Indra500 from the external
power source
Disconnecting the Phottix Indra Battery Pack
1. Turn off the power switch on the Indra500 TTL Studio Light.
2. Move the output toggle switch on the battery pack to the "OFF" position.
3. Unplug the flash power cord according to picture 4.
4. Unplug the other end according to picture 6.
Disconnecting the Phottix Indra AC Adapter
1. Turn off the power switch on the Indra500 TTL Studio Light.
2. Turn off the main power switch and output power switch on the AC Adapter.
Unplug the flash power cord according to picture 5.
3. Unplug the flash power cable from the Phottix Indra Studio Light (picture 6).
Attaching and removing the Reflector
To attach the reflector
1. Hold the Indra500 with one hand.
2. Align the reflector with the mounting slot using your other hand.
3. Insert and rotate the reflector clockwise following the direction of the arrow
in the diagram until the lock engages with a click. This ensures the reflector is