Description Of The Device; Use Of The Device - Mesko MS 4492 Manual De Uso

14.In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
15. Never touch the appliance with wet hands.
16. Use only the original accessories or recommended by the manufacturer.
17. Use the device only for its intended purpose. Do not use outside. Protect against
moisture.
18. When using the device, and especially when closing it, pay special attention to your
hands - do not put your hands into the sealing elements.
19. Do not use flammable objects.
20. The vacuum sealer is not suitable for packing liquids.
21. The vacuum sealer is intended for home use only.
22. Protect from moisture.

DESCRIPTION OF THE DEVICE

1. Product type setting / dry (1A) or moist (1B)
3. Air extraction & sealing button / cancel button
5. Cover lock
7. Welding strip
9. Sealing bar
11. Button for air extraction from the vacuum tank
13. Power cord
Tips for ready-made bags or rolls (foil sleeve):
1. Maximum width: 30 cm
2. Use only ready-made bags (open on one side) or foil rolls in the form of a sleeve (open on both sides) intended to vacuum sealing
(CR 4470.1)

USE OF THE DEVICE

In order to obtain proper welding, the foil should be clean, dry and free of creases in the welding strip (7).
Preparation of a bag from a roll of foil sleeve (open on both sides).
1.Depending on the size of the products, cut the required length of the bag.
2 Put the power cord (13) to socket (14) and connect to the power socket. The lamp (1A) will turn on (default setting).
2. Seal one side of the cut sleeve forming the bag:
a). Open the cover, place one side of the cut foil sleeve in the suction surface (6) so that it does not protrude behind the nozzles (10) as
shown in the figure A.
b). Close the cover by pressing down on the sides (Fig. B) to hear the "click" sound and press the button (2). The device will
automatically turn off after welding is completed.
c). Press both of the release buttons (4) to open the device.
I. Air extraction and welding
1. Put the items in the bag. Open the cover, place the other side (not welded) on the suction surface (6). Close the cover by pressing
(Fig. B) to hear the "click" sound.
2. By pressing the button (1) select the type of product inside of the bag.
* "Dry" – dry (1A)
* "Moist" – moist (1B)
3. Press the button (3) to start air suction and welding. The device will automatically turn off when welding is finished.
4. Disconnect the left and then the right cover opening buttons (4) first and lift the cover.
II. Extraction of air from external vacuum containers / bags
The set includes a tube (12) for sucking air from vacuum containers
1. Connect the container (not included) with the suction nozzle (10) using the tube (12) (Fig. C).
2. Press the button (11). The button will automatically turn off when air extraction is finished.
3. After air extraction, disconnect the device and the external vacuum container.
NOTE: when extracting air from external vacuum containers, do not close the cover to avoid deformation of the gasket (9).
2. Seal button
4. Buttons for opening the cover
6. Suction surface
8. Sealing sponge
10. Suction nozzle
12. Tube for evacuation of air from vacuum tank
14. Power socket
5