Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Sensor installation
1. Remove the tire valve caps.
2. Screw the locknut onto the
nozzle until it reaches the
bottom of the thread.
3. Install the sensors onto the tires
based on their marking. When
installing, hold the anti-slip gear
at the base of the sensor. Screw
the sensor onto the nozzle
thread and tighten it.
Note: Do not hold the case when
tightening the sensor. The position
indicator of the case and base should
not be misaligned, otherwise it may
cause the case to be loosened and the sensor to leak air.
03
Publicidad
Tabla de contenido
