Publicidad
Idiomas disponibles
Idiomas disponibles
Rated voltage
# 612... .. 2 .. ....
220 – 240 V 50 – 60 Hz
# 612... .. 1 .. ....
100 – 120 V 50 – 60 Hz
(Taiwan models)
Max. rated power
1080 W
Circuit breaker
I
RCD
I
Protection type
IP X4
Protection class
1
Pre-installation
> Install electrical connection in the specified areas,
see page 18.
DANGER
Risk of fatal electric shock
> Disconnect electrical components from the power supply
before the installation.
> Check that all components are de-energised.
> Prevent the power supply line from being switched on
accidentally by third parties.
> Ensure that there is no damage to the power supply cable.
> Lay a permanent power supply line which must be on a
separate circuit:
> Observe the position of the electrical connection
> Leave at least 800 mm (31½ ") of feed cable exposed
> Install circuit breaker
> If the product does not have electrical leakage protection
function, it must be installed in circuit where there is
leakage protection device installed.
> Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules and
having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions.
= 16 A
N
= 30 mA
N
Cold water
DN 15 (1/2 ")
Water pressure
0.07 – 0.75 MPa
(10 – 109 psi)
Water hardness
max. 2.4 mmol/l (240 ppm)
Pre-installation
> Install the water connection and water outlet in the specified
areas, see page 18.
Health risk and potential product
WARNING
damage!
> Supply the product with tap water from the main water
system only.
> Do not connect any waste water, grey water, industrial water,
sea water or other untreated or semi-treated water.
NOTICE
Product damage due to limescale build-up
In regions with hard water, limescale build-up can impair the
performance of the product.
> Check the water quality in your region. Duravit recommends
the installation of a water softener with water hardness
≥ 14° dH (2.5 mmol/l).
+
12
34
Connecting the water
NOTICE
Avoiding any malfunctions!
> The new hose-sets supplied with the appliance are to
be used and old hose-sets should not be reused.
Mounting_SeWa_Starck f_1pWC_CN_RE_57340/19.10.1
5
Publicidad
