Unpacking And Checking Contents; Unpacking; List Of Loose Parts; Assembly - RIDGID WORK-N-HAULIT AC9930 Manual Del Usuario

Unpacking and Checking Contents

Unpacking

NOTE: Before beginning assembly, check
that all parts are included. If you are miss-
ing any part, do not assemble this acces-
sory. Call 1-800-4-RIDGID or E-mail us at
info@ridgidwoodworking.com to get the
missing part. Sometimes small parts can
get lost in packaging material. Do not
throw away any packaging until the acces-
sory is completely
attached to your power tool. Check pack-
aging for missing parts before contacting
RIDGID.
A
NOTE: Only ONE spring pin is required at
the carry handle end of the stand. This
spring pin locks the legs in the set-up or
knock-down position.

Assembly

Assembling the Lower Foot
1. From carton and bag of loose parts
remove the following:
2 Hex Bolt, M6 x 41mm
4 Curved Washers M6
2 Hex Nuts M6
2 Assembly Wrenches
1 Lower Foot
1 Stand Assembly
*Some additional tools may be required to
attach your power tool to the stand. See
"Mounting Power Tools" section of this
manual.
All manuals and user guides at all-guides.com
assembled and
Instructions to
4

List of Loose Parts

Item Part Name
A Stand Assembly ...............................1
B Lower Foot .......................................1
C Bag of Loose Parts ..........................1
D Owners Manual ................................1
D
C
Carry
Handle
B
change the location of this spring pin are
described later in the "Assembly" section
of this manual.
Tools Needed for Assembly *
Assembly Wrench
M6 x 41mm
Hex Bolt
M6 Curved
Lower
Washer
Foot
Stand Assembly
Qty.
(2 Supplied)
M6
Lock Nut