Operation; Work Stand Set-Up; Before You Start - RIDGID WORK-N-HAULIT AC9930 Manual Del Usuario

Operation

Work Stand Set-up

Before you start:

• Remove any workpieces from the tool.
• If the tool is already assembled to the
stand, make sure that it is securely
attached to the stand per the instruc-
tions in this manual.
• Remove or securely store any tool
accessories such as clamps, miter
gauge, fence, guard, etc. that may be on
the work stand.
• For table saws, lower the blade all the
way down into the cabinet or base.
• For miter saws or other tools, lock the
cutter head or other movable portions of
the tool in the stored position.
Setting Up:
1. From the upright position, hold the leg
cross bar and pull the pin.
2. Lift legs up until they lock in place.
3. Lower unit until the legs rest on the ground.
4. At the wheel end of the stand firmly
grab the lift handle and with the other
hand pull the spring pin knob near the
right front wheel.
CAUTION: Do not lift by any part of
the power tool that is attached to the
work stand. Tool may be damaged.
CAUTION: When lifting, bend your
knees so you can lift with your legs,
not your back.
5. Pull up firmly on the lift handle until slid-
ing leg is vertical. Release the pin and
lower the handle to latch the leg. Shake
the handle up and down to make sure
the sliding leg locks into position before
releasing the handle.
NOTE: You may need to adjust the speed
at which you bring up the table in order to
get the sliding leg to latch.
WARNING: To reduce the risk of injury,
make sure sliding leg is secured in the
notch with the spring pin. Failure to
latch may cause stand to fall in use.
All manuals and user guides at all-guides.com
6
Upright Position
Leg Crossbar
Lift Handle
Lock the Legs
Spring Pin Knob
Sliding Leg
Pull
Pin