EGAmaster MASTEREX 76897 Manual De Instrucciones página 9

SWITCHING ON, RECEPTION AND SWITCHING OFF
1. To switch on rotate the on/off/volume control (1) on the top of the radio clockwise, you will hear
a click from the control.
2. When the radio has passed its diagnostic tests, it will emit a fanfare tone.
3. The radio will enter standby mode. This is indicated by the LED flashing amber once every 5
seconds, signaling that the radio is ready for use.
4. Adjust the volume control (1) to select the desired volume level.
5. Using the channel control (2), ensure you have the correct channel selected.
6. When receiving a valid signal, the LED will illuminate steady green and audio will be emitted
from the radio's speaker or audio accessory (if attached).
7. When finished using the radio, switch off by turning the on/off/volume control (1) counter
clockwise until it clicks and the radio will be switched off.
1. Perform steps 1 through to 5 above.
2. Before transmitting, monitor the channel and make sure it is clear.
3. When receiving a signal, wait until the signal stops before transmitting. The radio cannot
transmit and receive simultaneously.
4. Press the Push-To-Talk (PTT) button (4) to begin your transmission. To confirm transmission
the LED will illuminate red.
5. For best transmitted speech quality, you must talk directly into the radio's microphone (8) at
around 4cm between your mouth and the radio.
6. Please note: if you talk into the top of the radio or with your mouth further away, you will
transmit poor quality speech.
7. When the transmission is finished release the PTT button.
TRANSMITTING
9