Replacement Accessories - Craftsman CMCSTSB970 Manual De Instrucciones

English
Fig. J
17
18
Fig. K
MAINTENANCE

WARNING:
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.
Accessories

WARNING:
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN call 1-888-331-4569.

Replacement Accessories


WARNING:
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
or accessories.

WARNING:
not recommended by CRAFTSMAN for use with this
appliance could be hazardous.
10
To reduce the risk of
Since accessories, other than
To reduce the risk
The use of any accessory

WARNING:
or any accessory or attachment other than those
recommended by CRAFTSMAN on this trimmer.
Serious injury or product damage may result.
When replacing the line, use .080" (2 mm) or 0.095"
(2.4 mm) diameter line. Use CRAFTSMAN replacement line
Model No. CMZST080T5 or CMZST080TP. Other sizes may
degrade performance or cause damage to the trimmer.
Replacing Spool Assembly (Fig. L, M)
1. Rotate the spool housing
spindle plate aligns with notch
a screwdriver through the notch and into the hole, to
prevent the spindle 26
2. Unscrew and remove the spool housing by turning the
spool grip cover 20 clockwise.
nOTE: Do not try to remove the spool housing by turning
the spool head 27 .
3. Remove spindle plate
housing. Remove any dirt and grass from the motor
housing and spindle plate.
4. Install spindle plate onto the spindle, so the double D
shaped retaining nut on the spindle sits inside the base
of the spindle plate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new spool
housing counterclockwise. Securely tighten the new
spool housing onto the spindle.
Fig. L
24
20
27
Fig. M
Do not use any blades,
9 until the hole 24 in the
25 in the housing. Insert
from turning.
28 before installing a new
25
28
26
26
27
9