SPIT AC1600 Manual página 10

Operating instructions
10
AC_1600_binnen.indd 10
All manuals and user guides at all-guides.com
The ''AC'' –Auto Clean- function will enable the electromagnetic vibrator
to clean the filters (12) automatically every 2 minutes (the vacuum
cleaner's actual working time).
Once you select the ''AC'' position, the electromagnetic vibrator starts
systematically and works for 10 seconds.
To avoid inconveniencing the user, priority is always given to the working
of the electrical tool. In this case (more than 2 minutes of work), the
vacuum cleaner retains in its memory that it will have to vibrate. Once
the electrical tool stops, followed by the vacuum cleaner (prolongation of
suction for 10 seconds), the vibrator starts automatically and cleans
the filters within 10 seconds
SOCKET (2b)
The socket (2b) is meant for connecting an electrical tool.
Caution! While connecting the electrical tool, make sure that it has been
switched off (switch released!).
the socket (2b) when the electric cable (6) of the vacuum cleaner is
connected to the mains, regardless of the position of the switch (2a).
In position ''0'' of the switch (2a), the socket (2b) can be used as an
extension lead (example: for a lamp).
Available current intensity: vacuum cleaner + connected electrical tool = 16
Amperes maximum!
AIRFLOW INDICATOR (2c)
This indicator turns cherry-red when:
• the vacuum cleaner is full of dust
• the filter is clogged up by fine or damp dust
• airflow is disturbed
Caution: In case of reduced suction and low air volume (example: binding
stone core inside the bearing cap during dry drilling), the indicator (2c)
may remain activated permanently.. Cooling the engine internally in ''by-
pass'' enables you to work continuously without problems.
AIRFLOW CONTROL (2d)
This rotary knob (2d) is used to regulate the suction capacity
electronically. Maximum capacity is recommended for chasing, sawing,
and surfacing.
PROLONGATION OF SUCTION
In ''A'' or '' AC'' working mode, with an electrical tool connected to the
socket (2b), the vacuum cleaner's electronic system prolongs suction for
10 seconds after the electrical tool has been stopped. This enables you
to finish cleaning the dust or water which may remain in the suction pipe.
There is continuous power supply to
30-09-2005 14:21:59