RRC wm 24469 Manual De Empleo página 3

.uk
Usage Instructions
dependent upon the status of the vehicle´s battery it is possible

to experience a power outage. This can cause the connected
device to reset.
in order to avoid unneccessarily discharging the battery use the

car adapter with the motor running.
the car adapter automatically switches off if a certain low voltage

level is reached (under voltage protection).
in certain types of vehicles the car adapter can only be used if

the ignition is turned on. Please consult the user manual for your
vehicle or contact your vehicle reseller for more information.
the car adapter will become warm during use. The adapter is

fitted with an over temperature protection.
Replacing the Safety Fuse
The safety fuse is located in the cigarette lighter adapter (2). Remove
the red cap (turn anti-clockwise by hand and lift off) and then the
housing screw (with a screwdriver), the fuse can then be removed
from the fuse holder and replaced by a fuse of the same type (see
technical data). The connector should be re-assembled in the reverse
order. After assembly check that the you can push the centre pin of
the cigarette lighter (4) inside and that it is able to spring back. In
case of problem repeat the assembly process.
Technical Data
Input voltage
Input current
Standby current
Input fuse type
Output voltage
Output current
Output power rating
Operating temperature
Storage temperature
Measurements (LxBxH)
Total weight
Declaration of Conformity / Approvals
The car adapter complies to the current regulations of the EU
guidelines. The relevant conformity process contained therein has
been applied to this adapter and completed. The verification process
for electromagnetic interference
89/336/EU, 91/263/EU, 92/31/EU and the following harmonised
norms: EN55032 Class B, EN55024.
norms have also been applied:
DIN40839/ISO 7637, RTCA-DO160D (-20 / -21). Although the car
adapter conforms to the current strict guidelines and norms it is not
possible to guarantee that other devices will not be affected by
interference.
FCC Advice
This device complies with part 15 of the FCC Regulations. Operation
is subject to the following two conditions:
This device may not cause harmful interference, and

This device must accept any interference received, including

interference that may cause undesired operation.
UL Advice
Caution: The UL Listing investigation only covers the use of this
product in land-based vehicles. It does not imply or cover the use
on an aircraft.
E
NGLISH 
10.5 to 32V ±0.5V
max. 9A
max. 80mA
Conquer, Type UDA 10 A, 250 V
type dependent
type dependent
max. 72W (at 25°C)
-20 to 35°C
-40 to 85°C
111x48x35mm
260 g
follows the EU guidelines
Furthermore the following
EN55025, FCC15 part
3
B,