Installation - brondell MBH-10 Manual De Instrucciones

PRODUCT INSTALLATION

Installation

Please read these instructions carefully before installing
your Hand-Held Bidet Holster with Integrated Shut
Off. Failure to do so could result in flooding, leaking or
damage to the product.
1. Existing Toilet Seat Removal
a. Lift hinge covers and use flathead or Phillips
head screwdriver to remove the mounting bolts.
Alternatively, you may need to loosen mounting
bolts underneath the seat.
b. Remove the toilet seat and set the seat, mounting
bolts and hardware aside.
2. Turn Off Water Supply Valve and Flush Toilet
a. Turn water supply valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely
empty tank.
c. Disconnect water supply hose from toilet tank.
Do not disconnect from the water supply valve.
d. If you have a hand-held bidet sprayer already
connected to your toilet tank, remove the existing
T-valve and hand-held bidet sprayer connection
hose.
3. Connect Cold Water T-Valve to the Toilet Tank Fill Valve
a. Install the included ⅞" cold water T-valve with the
large rubber washer provided to the incoming water
connection on the bottom of your toilet tank.
b. Connect the cold water supply line coming from the
wall to the bottom of the T-valve.
4. Connect Cold Water Hose to T-Valve
Connect one end of the Cold Water Braided Metal
Hose to the remaining open side of the installed
T-valve.
Step 1b
Step 2c
Step 3a
Step 3b
Step 4
5