Servicing And Maintenance; Troubleshooting - Virax Eurostem III 251873 Manual De Instrucciones

Bend range
0° – 180°

7 Servicing and maintenance

WARNING: disconnect the battery before any adjustment or maintenance operation.
Check regularly all the fastening elements to ensure they are fastened tight.
Do not over-grease the counter-form adjustment screw, use a light application of grease with a brush.
Check regularly the good condition of the forms and counter forms.
Make sure the engine cooling vents are not obstructed. Remove the accumulation of dust and other impurities. Do not insert sharp objects.
Compressed air is effective for cleaning.
Do not let any liquid enter the engine cooling vents.
Repair work on the charger may only be carried out by a specialist!
For any repairs to your machine, we recommend that you contact the Virax after sales service center.
IMPORTANT NOTES:
• Any lack of servicing may be detrimental to proper operation of the crimper, and may cause severe body injury to the user.

8 Troubleshooting

WARNING: Leaving the battery connected before adjusting or changing accessories may cause severe body injury.
Issue Diagnosis
Almost empty battery pack, the electronic system
protects the battery from damage due to total
discharge.
If the machine is loaded for too long, it will stop
automatically due to overheating of the battery or
the motor.
If the machine
stops by itself + If the machine is overloaded, it will stop
beep. automatically due to overcurrent (e.g. when
bending materials and/or pipe sizes not described
in the technical data).
The speed suddenly drops due to a mechanical
blockage, the machine goes to safety and stops
automatically.
The motor turns
but the bending The clutch lever is in the wrong position or is not
form does not properly engaged.
turn.
20
Tripod
horizontal position
Tripod
vertical position
Solution
If an LED on the battery is flashing, the battery is almost
empty. Recharge it.
Allow the battery and motor to cool.
Respect the bending capacities defined in the technical
data chapter.
Repeated overloading can lead to serious electrical
and/or mechanical damage.
Stop the machine with the trigger and restart work
normally. If the problem persists, contact Virax SAS.
Check that the clutch is in the correct position or fully
engaged. If the problem persists, contact Virax SAS.
EN
Danger zone of
moving parts