Becken BKGH4446 Manual De Instrucciones página 31

Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown
burners as follows:
1. Place the flame spreader (4) on to the burner cup (5) so that the
ignition device and the flame supervision device extend through their
respective holes in the flame spreader. The flame spreader must click
into place correctly.
2. Position the burner lid (1,2,3) onto the flame spreader (4) so that the
retaining pins fit into their respective recesses.
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating pins must fit exactly into the notches.
Warning
• Never use abrasive or caustic
cleaning agents.
Built-in Gas Hob | Encimera Vitrocerámica Gas | Placa Vitro Gás
EN
31