Care And Maintenance - LF AquaSource T802D 0806386 Instrucciones De Instalación

8. Install Seat
Place seat (C) on bowl (A), centering the hinges over the holes
in the bowl. Open the hinge covers, insert plastic seat bolts (KK)
onto plastic seat bolts (KK) from underneath the bowl (A). Use a
screwdriver to secure seat lock nuts (LL). Close hinge covers.
9. Install Flush Button
Position flush button (OO) on top of the tank lid (D) so the small
button with the blue rod (half flush) will align with the green button on
top of the flush valve per-assembled to tank (B) and the larger button
with the white rod will align with the white button (OO) in tank lid (D)
by hand tightening.
The flush button (OO) may have been assembled at the factory.
NOTE: Make sure the tip on the bottom of the push rods leading from
the flush buttons lightly touch the top of the levers on the flush valve. To
increase the rod length, turn the rod locknut counterclockwise to loosen,
then rotate the push rod counterclockwise to increase exposed length.
When desired length is achieved, turn the rod locknut clockwise while holding
the push rods until it is tightened. To shorten the rod length, turn the rod locknut
counterclockwise to loosen, then rotate the push rod clockwise decrease exposed length.
CAUTION: Do not use in-tank bowl cleaners as they can contain aggressive chemicals that attack the tank
components and will void the warranty.
• After installation, flush several times and check for leaks.
• The small button is for a light flush that takes away only liquids. It uses only 1.1 gallons of water.
The larger button is for a complete flushing action that takes away solids and liquids.
This flush uses 1.6 gallons of water and is a standard flushing action that
disposes of waste and cleans the basin.
• Always test cleaners on a small, inconspicuous area first.
• Always use soft cloths or sponges to clean the surface. Using abrasive materials may damage the surface of the toilet.
• Flush valves are set at the factory and should not need adjustment.
• Always rinse cleaning solutions from the surface immediately after cleaning. Do not let chemicals remain on the toilet
surface for extended periods of time.
INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

C
5
KK
MM
LL
OO
(3 inch)
Solid