Before You Start Operating; While Operating - VITO PRO POWER VIBE850 Manual De Instrucciones

Taladro con percusión
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not expose the power tool to rain or operate it in wet or
damp conditions. The presence of water in a power tool
increases the risk of damage and electric shock to the user.
Only hold the power tool by its insulated surfaces, which
prevent electric shock if the power tool comes into contact with
hidden wires or power cord during operation.
Never use the power cord to pull, carry or unplug the power
tool. Damaged power cords increase the risk of electric shock.
Keep the power cord and plug away from heat sources, oil,
sharp objects and rotating attachments. Check the condition of
the power cord regularly, if it is damaged, it must be replaced
or repaired by a qualified technician.
Never change the power cord plug and use a socket which is
compatible with the plug. Do not use any kind of socket adaptor.
The use of extension cords to plug in the power cord is not
recommended. However, if you use an extension cord, you
should take some precautions, such as:
▪ If you operate the power tool outdoors, use only extension
cords suitable for outdoor use. The use of a suitable
extension cord reduces the risk of electric shock;
▪ Use only extension cords, plugs and sockets with grounding;
▪ The cross-section of the extension cord's cables shall be
proportional to the length and with the same characteristics
as or larger than the appliance's power cord;
▪ Do not use damaged extension cords. Examine the extension
cords before using them and replace if necessary;
▪ Always unplug the extension cord before removing the plug
from the power tool;
▪ When using an extension cord reel, unroll the cord
completely;

Before you start operating

Individuals who have not read the instruction manual and are
not familiarized with how to operate the impact drill must not
use it.
To ensure that you work with the power tool safely, you should
consider a few precautions and procedures before start-up:
▪ Inspect the power tool before each use. Check that all
attachable accessories are assembled correctly and in good
condition. If there is damage or excessive wear, replace
them;
▪ Check that all screws are properly tightened.
inspection is important to ensure safety issues and the
performance of the power tool;
▪ After the accessories' assembly and before using the power
tool, test it at full speed with no load for a while. Check for
moving parts misalignment or any other condition that may
affect the impact drill operation. Check that all moving parts
run smoothly, without abnormal noises and sparks on the
carbon brushes;
▪ Check that the safety devices are in perfect condition and
function properly. Never use the power tool if the safety
devices are missing, inhibited, damaged or worn out;
▪ If the ON/OFF switch is damaged or does not allow the
operation of the tool to be controlled, it must be repaired or
replaced in order to prevent any accidental start;
Make all adjustments and work necessary for the correct
assembly of the impact drill. If you have any questions or
difficulties, contact your official distributor.

While operating

Keep third parties away from the power tool's area of
operation. Never work while animals or people, especially
children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to 300 lux),
thus decreasing the risk of accidents.
Regular
27

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido