Parts List - Parweld XR935H Guía De Instrucciones

XR935H -
PLEASE NOTE
Grind mode is intended for grinding and not for welding. Before you restart welding
please set the fi lter back to weld mode and select the required shade for your application to do this rotate
the shade knob anti-clockwise.

PARTS LIST

XR320
Front Cover
Lens
MAINTENANCE
REPLACEMENT OF FRONT COVER LENS
• Remove the front cover lens by pulling outwards at the base of the lens using the fi nger slot provided.
• Make sure the protective fi lms are removed from new cover lens.
• Place the new cover lens in the recess at the front of the helmet.
• Locate the cover lens under the lugs at the left of the fi lter and then fl ex the lens so that it can be inserted
under the lugs on the right had side of the fi lter.
• Only use genuine Parweld cover lenses, using lower grade lens may cause warping and allow spatter to
damage the fi lter so invalidating the warranty. This may also reduce the impact rating.
NOTE- Do not use the helmet without the cover lens in place.
REPLACEMENT OF INNER COVER LENS
• The welding inner cover lens is removed by pulling out the top edge.
• The new inner cover lens is assembled after the protective fi lm is removed. Locate one of the sides by
inserting the edge under the frame at the side and bend the lens in the middle part and locate the lens
under the frame at the other side.
Everyday Light Reactive Welding and Grinding Helmet
XR935
Helmet Shell
XR330
Inside Cover Lens
XR350
Cartridge
- ENGLISH
XR440
Adjustable
Headband
5