1
ACCESSORIES
Remote controller
Batteries (two)
■
Names and functions of indicators
and controls on Wireless receiver
Display panel
1
2
The operating conditions are indicated below.
1
OPERATION (White)
This lamp goes on during operation.
2
TIMER (White)
This lamp goes on white the timer reserved.
NOTE
In case of timer setting by wired remote controller,
TIMER lamp does not light.
In case of group control, TIMER lamp goes on header
unit only. (see "4 LIMITED OPERATION
BY GROUP CONTROL")
3
Preheat/Defrost (White)
This lamp lights up when the power is turned on or
right after heating operation starts or during defrost
operation.
Remote controller holder
• Disagreement in operation mode
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/ heating) control
3
setting or if you select HEAT in a Cool Only model,
an alarm sound (pi, pi) from the air conditioner due
to disagreement in operation mode. Change the
operation mode with the MODE button on the wireless
remote controller. This disagreement indication cannot
4
be deleted by the wired remote controller.
• When local prohibition is set by the central control
from other equipment, no signal is received even if the
remote controller button is pressed. However, a signal
of START/STOP button is accepted. (An alarm sound
"pi " arises intermittently five times.)
4
TEMPORARY operation
If you misplace or lose the wireless remote
controller or its batteries are exhausted, push the
temporary operation button.
• Push the temporary operation button to start the
- 2 -
Wireless receiver
CAUTION
air conditioner. Push this button once again to
stop it.
Operations Manual
EN
2-EN