SOLAC CP7304 Instrucciones De Uso página 11

HOW TO CUT THE HAIR:
- Situate the person whose hair
you are going to cut so that the
top of their head is at your eye
level. Place a protective towel
or cloth around their neck.
- To obtain best results is better
to use the appliance on dry
hair, as it is much easier to
control the hair and the result.
- Comb hair well before cutting.
Make sure that there are no
tangles or knots.
- Hold the appliance in a calm
and relaxed manner in order
to ensure maximum control of
the cut and a uniform result.
Proceed to use short cuts gra-
dually going around the head.
- Leave the hair a little longer
than desired length as it can
always be altered later.
- While working adapt the comb
/ comb guide to the desired
result
- At regular intervals, stop cut-
ting in order to comb the hair
and check the results so far.
Step 1 Nape:
- Attach comb guide size
3-18mm (E)
- Hold the appliance with the
razor facing downwards and
begin to cut the hair from the
base of the neck.
- Make some upward move-
ments, raising the appliance
gradually and away from the
head, cutting the hair gradually
until the height of the ears
(Fig 2)
Step 2 The back of the head:
- Attach comb guide (E) and
continue with the back of the
head (Fig 3)
Step 3 The side of the head:
- Attach comb guide (E) to trim
the sideburns and continue
until you reach the top of the
head.
Step 4 The top of the head:
- Using comb guide (E), pass
the appliance from the back to
the front, against the growth of
the hair (Fig 4). In some cases
it's necessary to go over what
you have done a second time
from front to back.
- The comb guide (E) is for
when you want to achieve a
more precise cut.
- Always work from the back to
the front reducing the length
between your fingers or the
comb and the head gradually.
Step 5. Final touch
- Finally use the appliance
without attaching any comb
guides to the blades to cut the