Connecting and disconnecting the gas bottle
Parts and tools needed
excluded
The tube shall be readily visible across its entire length f
inspection after installation.
DANGER! IGNITION OF ESCAPING GAS
Possible consequences:
Safety measures:
Operational Elements:
lever/
9o'clock setting or rotate clockwise to the end:
Cylinder valve
12o,clock setting or rotate anti-clockwise to the end:
than
LIGHTING INSTRUCTIONS:
1. READ OPERATIING INSTRUCTIONS BEFORE LIGHTING.
2. OPEN LID.
3. ENSURE KNOBS ARE IN "●" POSITION.
4. CONNECT REGULATOR WITH CYLINDER,THEN TURN ON.
5. PUSH AND TURN CONTROL KNOB ANTI-CLOCKWISE TO
APPROX 1/4 POSITION UNTIL A CLICK IS HEARD AND
BURNERS LIT.
or
6. ADJUST THE FLAME BETWEEN 1/4 TO 1/2 AREAS.
! WARNING
OUTDOOR USE ONLY. IF IGNITION DOSE NOT OCCUR WITHIN
5 SECONDS, TURN CONTROL KNOB(S) TO "●". WAIT 5 MINUTES
TO ALLOW GAS TO DISSIPATE AND REPEAT LIGHTING PROCEDURE.
ACCESSIBLE PARTS MAY BE VERY HOT, KEEP YOUNG CHILDREN AWAY.
DISCONNECT REGULATOR FROM CYLINDER WHEN THIS APPLIANCE
NOT USE IN A LONG TIME.
WARNING:
LID MUST BE OPEN WHEN BURNER IS ON OR HOT.
MAXIMUM WEIGHT ON SIDE SHELF: 6.8 KG / 15 LB
Function
rotate to the end
cylinder
Note
1-A
G5
9
G1
G2
12
G3
G4
1/4 position
1/4 to 1/2.
1-B
G1
G2
9
G4
G2
G4
setting or anti-clockwise
opened
G2
G4