Operation - Echo 99988805000 Manual Del Operador

OPERATION

4.
There are two ways to pressurize your water tank
Option 1
Unscrew the pumping tube and remove it from the tank.
Pour the water up to the indicated level marked in the tank.
Replace the pump tube and screw it tightly, then pressurize the unit.
Option 2
You can pressurize the water tank with the Schrader valve located in the superior part of the tank, to do so, follow this instructions:
Unscrew the pumping tube and remove it from the tank.
Pour the water up to the indicated level marked in the tank.
Replace the pump tube and screw it tightly, then pressurize the unit.
- To pressurize the tank you need an external air supply.
- Once you have the external air supply, remove the cap from the shrader valve.
- Inject compressed air to the valve until its full and put the cap back on.
- The water tank is now ready to be used.
for string head installation and maintenance instructions.
• All SB-Series, Multipurpose Tool attachments, and PRO ATTACHMENT SERIES Split Shaft attachments carry the same warranty
• All hand tools are covered by a limited lifetime warranty. Warranty is handled through ECHO's Consumer Support Department. For
due to misuse, mis-strike, abuse, or neglect is not covered by warranty. If you feel the handle broke prematurely due to a defect, please
WARNING
Do not use chemicals with this tank.
NOTE:
To take the pressure out in each option you need to pull the release valve up
with your fingers Make sure you take all the air out before opening the tank.
NOTE:
The Schrader valve activates when the tank is full, this is
when you stop pumping. It does not have a specific level,
you should inject air until the release valve activates.
3
NOTE:
The pump tube must be tight
otherwise the applicator
will leak and will not hold
pressure.
NOTE:
To ensure the best performance
use only ECHO
original spare parts.