ECRON AD 836A Manual De Usuario página 39

BLADE LEVER
· The lever is conveniently located
near your thumb (if right handed)
so that it can be easily adjusted
while the cutter is in your hand.
· The lever adds versatility to your
cutter, allowing you to gradually
change the closeness of the cut
without adding the comb.
Close cut
· The cut will be close and the hair
very short when the blade is in the
highest position. Pushing the
lever gradually downwards
increases the length of the cut.
· Hair will be the same length as
comb #1 when the lever is in the
lowest position.
Long cut
· The lever will also extend the use of
its blades since a different cutting
edge is used in each setting.
· Also, if cutting very thick hair has
clogged the blades, it will help
remove the hair that got stuck
between the blades without
removing them.
· While the cutter is working,
quickly move the lever from "close
cut" to "long cut" a couple of
times. Doing this each time you
have finished using the cutter will
help it keep the blades free of cut
hair. If your cutter stops cutting
and this does not help, your
cutting blades may be dull.
Replace them with new blades.
EN
39