Makita XFD06 Manual De Instrucciones página 8

Guideline of fastening torque
Adjusting graduations
Machine screw
Wood screw
013981
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or drill bit
013956
Turn the sleeve counterclockwise to open the chuck
jaws. Place the bit in the chuck as far as it will go. Turn
the sleeve clockwise to tighten the chuck.
To remove the bit, turn the sleeve counterclockwise.
Hook
2
014005
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1 2
M4
Soft wood
(e.g. pine)
Hard wood
(e.g. lauan)
1. Sleeve
1
1. Groove
2. Hook
3. Screw
1
3
4 6 8
M5
3.5 x 22
3.5 x 22
Installing bit holder (Optional accessory)
1
2
013966
Fit the bit holder into the protrusion at the tool foot on
either right or left side and secure it with a screw.
When not using the driver bit, keep it in the bit holders.
Bits 45 mm-long (1-3/4") can be kept there.
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If
not, it may accidentally fall out of the tool, causing
injury to you or someone around you.
When the speed comes down extremely, reduce
•
the load or stop the tool to avoid the tool damage.
013961
Hold the tool firmly with one hand on the grip and the
other hand on the bottom of the battery cartridge to
control the twisting action.
8
10 12 14
M6
4.1x 38
4.1x 38
1. Bit holder
2. Bit
16