Assembly/Pre-Operation; To Assemble The Grass Catcher - Evans PoulanPro Manual De Operador

SETUP

ASSEMBLY/PRE-OPERATION

Read complete REFERENCE GUIDE before operating
this machine.
IMPORTANT: THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR
GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory with the
exception of those parts left unassembled for shipping purposes. All
parts such as nuts, washers, bolts, etc., necessary to complete the
assembly have been placed in the parts bag. To ensure safe and proper
operation of your lawn mower, all parts and hardware you assemble
must be tightened securely. Use the correct tools as necessary to
ensure proper tightness.
SETUP
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and
lower handle and padding holding operator presence control bar to
upper handle.
4. Roll lawn mower out of carton and check carton thoroughly for
additional loose parts.
HOW TO SET UP YOUR LAWN MOWER
IMPORTANT: Unfold handle carefully to avoid pinching or damaging the
control cables.
1. Raise handles until lower handle
section locks into place in
mowing position.
2. Insert handle bolts into lower
handle. Install and tighten
Knobs to secure the handle.
3. Remove protective padding,
raise upper handle section into
place on lower handle.
4. Tighten Knobs to secure the
handle.
5. Remove handle padding
holding Operator Presence
Control Bar to upper handle
(IF EQUIPPED).
NOTE: For some models, the lawn
mower handle can be adjusted for
your mowing comfort. Refer to the "TO ADJUST HANDLE" section of the
Operator's Manual.
anual_16HQ003 Poulan Walk Behind EN_SP_115847196-A_preprensa.indd Pliego 8 de 14 - Páginas (8, 21)
2
8
6. Loosen knob on upper handle.
7. Slowly pull engine Starter
Handle.
8. Slip starter rope into loop on
upper handle.
NOTE: Make sure loop is facing UP.
9. Tighten Knob.
TO ASSEMBLE THE GRASS
CATCHER
1. Put the Grass Catcher frame
into the grass bag with the rigid
part of the bag on the bottom.
Make sure the frame handle is
outside of the bag top.
2. Slip the vinyl bindings over
the frame.
TO PREPARE BATTERY
(IF EQUIPPED)
NOTE: Your battery must be charged
before you can start your lawn
mower using the electric start.
1. Open the Battery Box or the
Battery Port.
2. Connect the battery charge
connector (male) to the harness
connector (female).
3. Plug the battery charger into a
110 volt A.C. (60 Hz) outlet.
4. Leave the battery charger
connected for 24 hours before
starting your engine using the
electric starter.
2
2
2
1
3