Troubleshooting Guide - JBM 53220 Manual De Instrucciones

Limpiadora de piezas portátil
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
DETERGENT FILLING PROCEDURE
1.Make sure the depletion cap on the side of the unit is tightly secured.
2.Remove drain plug and fill in recommended detergent (water soluble cleaning agent). The tank volume is 20 litres.
Note:
Do not use Flammable solvents (gasoline, toluene, thinner and etc.)
OPERATING INSTRUCTION
1.Open the lid.
2.Make sure at least 15L of detergent inside the tank. (Do not allow the level of detergent fall below pump inlet or the pump may be
damaged).
3.The detergent can be recycled and used for next operation.
4.Turn on the switch on the side of the unit to start the operation.
:
Note
Certain models don't equip with power switch. Once plug in the power cord the pump is in operation.
5.Wash parts in the basin, using brush to clean off any heavier deposits.
6.Allow parts to drain until cleaning agents stops dripping.
7.Unplug and close lid when finished.
8.Clean the filtering net periodically in the basin.
DETERGENT REPLACED PROCEDURE
1.Open the depletion cap on the side of the unit. Pour out waste detergent into recycle tank.
ACCESSORIES FOR DIFFERENT CONFIGURATIONS

TROUBLESHOOTING GUIDE

PROBLEMA
Wash pump will not
1. Power cord unplugged
run
2. Blown fuse
3. Pump is broken
Wash pump runs but
1. Solvent level low.
solvent does not flow
2. Clogged pump/spout.
3. Pump is broken.
Vacuum pum p sounds
1. Debris caugh tin pump.
too loud
2. Pump is broken.
Too much solvent in
1. Holding tank has overflowed
wash basin
into wash basin.
2. Pump is broken.
POSIBLE CAUSA
1. Make sure power cord is connected.
2. Check circuit breaker or outlet for blown fuse.
3. Call Customer Service.
1. Remove strainer basket and check the solvent level. Transfer
additional solvent to the wash basin.
2. Check for clogs in the wash pump and/or spout.
3. Call Customer Service.
1. Look for debris underneath the pump, debris and rebalance.
2. Call Customer Service
1. Remove all excessfluid and runa distillation cycle tomove clea-
ning agent back into the holding tank
2. Call Customer Service
· 7 ·
SOLUCIÓN

Publicidad

Tabla de contenido
loading

Tabla de contenido