Tecnimoem Powerlift 150 Manual De Usuario página 37

POWERLIFT 150/135 Mini/175 User manual
3.2. Joining the pre-assembled structures
Place the base structure on the floor with the brakes on the rear wheels (3) on.
Remove the locking knob (14), DON'T REMOVE THE GREY PLASTIC PIECES OF THE
MAST BASE and insert the mast-boom structure in the mast base (1). Align the
holes in the mast (6) and base and put the locking knob (14) back in place, making
sure it is tight and secure.
Check that the legs (4) open and close correctly and that the wheels rotate freely.
The actuator (10) is supplied and mounted on
the hoist in the factory. If you need to disas-
semble the actuator, loosen the ring (a) secu-
ring the pin (b). To reassemble do the opposite
operation. (picture 2)
Picture 2
38