DFI AD75 Manual Del Usuario página 14

All manuals and user guides at all-guides.com
1
Quick Setup Guide
1.3.7 IrDA Connector
1 2 3 4 5
1.3.8 Floppy and IDE Disk Drive Connectors
Primary IDE
If you encountered problems while using an ATAPI CD-ROM drive that is
set in Master mode, please set the CD-ROM drive to Slave mode. Some
ATAPI CD-ROMs may not be recognized and cannot be used if
incorrectly set in Master mode.
14
1 VCC
2 N. C.
3 IRRX
4 Ground
5 IRTX
The sequence of the pin functions on
some IrDA cable may be reversed
from the pin function defined on the
system board. Make sure to connect
the cable to the IrDA connector
IrDA
according to their pin functions.
(J16)
FDD
(IDE 1)
Secondary
IDE (IDE 2)
FDD IDE