Technical Data - Weidmuller Digi-Check 5.2 Instrucciones De Empleo

Digi-Check 5.2 04.12.2003 15:02 Uhr Seite 13
Instructions for Use
GB
Microprocessor-controlled DIGITAL voltage tester displaying DC and
AC voltage with signal buzzer. Automatic measurement range selec-
tion.
Description
k
Test probes Resistance measurement
h
k
Voltage indicator (LED)
Capacitance meas-
i
urement
Clip
k
Display held
j
LCD display (4-digit)
k
Background illumination
k
k
Phase sequence test
a
k
l Polarity indicator
k
b Phase test
HOLD button
k
Low bat display
c
ON/MODE button
k
Bar graph display
d
LOAD button
k
e Digital voltage display
Battery compartment
k
Direct or alternating
f
Contact electrode
voltage
k Illuminated test probes
Frequency measurement
g

Technical Data

≥ 400 kOhm
Input resistance: R
i
approx. 2.5 k ohms in
conjunction with "LOAD"
Rated voltage range: 5* – 690 V AC/DC
* display starts as from 0.3 V
Resistance and continuity test: 0–2000 ohm
(digital display + signal buzzer)
Frequency testing/ 0–2000 Hz; in 1-Hz increments
frequency range: AC display from f > 20 Hz
Capacitance testing: 1–50 µF in 0.1-µF increments
Display ranges for voltage testing
0.3–24.0 V AC/DC This range is displayed to one
decimal place (e.g. 10.5 V) +
LED* On + signal buzzer**
Resolution 0.1 V
24–240 V AC/DC This range is displayed with no
decimal place (e.g. 230 V) +
LED On + signal buzzer
Resolution 1 V
240–450 V AC/DC This range is displayed with no
decimal place (e.g. 400 V) +
LED On + signal buzzer
Resolution 2 V
450–690 V AC/DC This range is displayed with no
decimal place (e.g. 500 V) +
LED On + signal buzzer
Resolution 5 V
13