Uline KOALA KARE H-9601 Manual De Instrucciones página 3

5. Place chassis over screws using keyhole slots.
Verify that the unit is level. (See Figure 4)
Figure 4
6. Tighten top two screws to be flush with the wall.
7. Use the four lower holes as a guide to mark and
drill pilot holes. Use remaining four 1/4 x 3" pan
head wood screws and four washers to complete
installation of bed and mounting bracket.
(See Figure 5)
NOTE: All six screws and four washers must be
properly mounted to the chassis.
Figure 5
PAGE 3 OF 12
INSTALLATION CONTINUED
8. To install liner dispenser, unlock and open liner
9. Align dispenser mounting holes onto chassis and
10. Inspect unit to ensure it opens and closes smoothly.
dispenser lid using key. This will expose liner
dispenser mounting holes. (See Figure 6)
Figure 6
Dispenser Lid
secure with four 8/32 x 5/16" Phillips button head screws.
(See Figure 7)
Figure 7
When finished, close and lock the liner dispenser door.
Liner Dispenser
0322 IH-9601