Intended Use; Operating Instructions; Assembly And Operation - Worx WX031 Manual Original

the accessory packaging for further details. Store
personnel can assist you and offer advice.

4. INTENDED USE

This machine can be used as both vacuum cleaner and
blower. With the strong suction power, it can easily
pick up wet and dry messes.

5. OPERATING INSTRUCTIONS

NOTE: Please read the instructions carefully
before use.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Take out all accessories
Unhook the tank latches on each side
to open the lid and take out all the
accessories.
Hose hook assembly
Install the hose hook onto the lid, facing
it upward.
Assembling the shoulder strap
Function selection
This machine has the suction inlet
(Position 1) and blower outlet (Position
2) separately. Connect the hose to the
proper port depending on your work.
Function as a vacuum
Insert the hose into the suction inlet
(Position 1).
Nozzle assembly
When using as a vacuum, you can
choose wide nozzle and crevice nozzle
depending on different working needs.
Function as a blower
Insert the hose into the blower outlet
(Position 2).
Checking the battery charge condition
NOTE: Fig. F1 only applies for the bat-
tery pack with battery indicator light.
Charging the battery pack
Installing the battery pack
OPERATION
20V Cordless Wet/Dry Vacuum
Turning on the machine
Press the on-off switch to start operation.
Power Selection
When the switch is pressed for the first
time, the machine starts and works at
high speed. Press the ECO button for a
low speed. Press it again, the cleaner will
switch to high speed. To stop, press the
ON/OFF switch again.
NOTE: When working under high speed,
the light is not on. When working under
ECO mode, the light shows green.
WARNING: Please keep the air
intake unobstructed, otherwise it
may cause motor overheating and may
damage the machine.
FIGURE
Using as a vacuum cleaner
Dry Vacuuming
Vacuum items only small enough to
See Fig.
fit through the hose. When vacuuming,
A1, A2
make sure that the filter stays in place.
The performance of the vacuum will
decrease with a full collection container.
When emptying the collection container,
See Fig. B
check to see if the filter needs cleaning.
Attention:
1. Do not suck sharp objects such as nails
See Fig. C
into the vacuum.
2. Do not suck objects with high
temperature such as carbon ash. Please
let it cool down first.
3. Clean the HEPA filter regularly.
Wet Vacuuming
This machine is equipped with double-
probe detector, which is designed to
shut off the suction when the collection
container reaches full wet capacity. When
See Fig.
the collection container is full, empty
D1, D2
the collection container as shown in
Maintenance.
Attention:
1. Put the machine on the flat ground.
2. Make sure the filter is completely dry
See Fig. E
after picking up water or wet debris.
Using as a blower
Open the rubber cover on position 2
See Fig. F1
to start using the air blowing function
and put it back to its original place after
completion.
See Fig.F2
WARNING: Never point the nozzle
at anyone in the vicinity.
See Fig.F3
See Fig.
G1, G2
11
See Fig.
H1, H2
See Fig. I
EN