Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
The next level of priority is formed by the PRIORITY contact closure (which activates the chimes) and messages 1 or
2. These inputs have priority over the auxiliary inputs (AUX 1, AUX 2 o AUX 3), which will remain attenuated as long as
the message is active or the PRIORITY contact closure is closed.
MESSAGE PLAYBACK
To play messages 1 or 2, select the message you wish to play using the contact closure on the rear panel. Then press
the PLAY MESSAGE button on the front panel to play it and the STOP button if you wish to stop playback.
Note: for message playback, the PLAY MODE selector must be in ALARM mode.
To play message 3 press and hold the ALARM button on the microphone mod. M-203. The message will be broadcast
in the selected zones if the mixer is configurated in NORMAL mode, or in all the zones if the mixer is configurated in
ALARM mode. The message will be played continuously until the ALARM button is pressed.
CONNECTION
Make the connections with the amplifier and all the components of the audio system switched off and disconnected
from the power supply.
Please note that the loudspeaker load of the 6 zones must not exceed 1,000 W in total and 500 W in each zone
individually.
The system can operate as an auxiliary line switching unit, which requires one amplifier per zone, or as a 100 V line
switching unit, with one amplifier for background music and another one for paging.
Once the connections have been made according to your needs, connect the devices to a power supply and switch
them on. After use, do not forget to switch off and disconnect the devices from the power supply.
MICROPHONE CONNECTION M-203
The connection cable between the M-203 microphone and the MXZ-2036 amplifier is made using a straight thought
wiring data cable (pin 1 at one end is connected to pin 1 at the other end, pin 2 to pin 2, etc.) of Cat.5e or higher. You
can connect the cables according to the following colour code:
NOTE: connectors must have the cable shield connected.
In the case of there being more than one microphone, these are connected in cascade through the LINK OUT output
of the first one towards the LINE IN of the second.
Once the connections have been made according to your needs, connect the devices to the mains and switch them
on. After use, do not forget to switch the equipment off and disconnect it from the mains.
1 Azul
5 Naranja
2 Azul-Blanco
6 Naranja-Blanco
3 Marrón
7 Verde
4 Marrón-Blanco
8 Verde-Blanco
1 Blue
5 Orange
2 Blue-White
6 Orange-White
3 Brown
7 Green
4 Brown-White
8 Green-White
1 Bleu
5 Orange
2 Bleu-Blanc
6 Orange-Blanc
3 Marron
7 Vert
4 Marron-Blanc
8 Vert-Blanc
1 Azul
5 Laranja
2 Azul-Branco
6 Laranja-Branco
3 Castanho
7 Verde
4 Castanho-Branco
8 Verde-Branco
1
8
1
1
8
1
1
8
1
1
8
1
- 6 -
8
8
8
8
Publicidad
Tabla de contenido
