Blendtec COMMERCIAL Serie Manual Del Propietario Y Guia Del Usuairo página 49

6.1 BLENDER MOTOR WILL NOT TURN ON (NO POWER)
If the blender motor will not turn on, try the following:
• For the Stealth 875 and Chef 775 look to see if the control surface has an
illuminated power icon, for the Stealth 885, Connoisseur 825, EZ 600 and
Chef 600 determine if the Liquid Crystal Display (LCD) is lit� Absence of those
indicators indicates a lack of power to the unit�
• Check your circuit breaker switch or fuse to make sure it is set to the
ON position�
• Unplug the power cord from the wall receptacle, wait 5 seconds, then plug
power cord back in�
6.2 ERROR MESSAGES ON DISPLAY
STEALTH 875™/STEALTH 885™
Touch Error — This indicates that more than one touch sensor on the blender has
been touched� To avoid this message, touch the center of the desired button�
If this icon remains on when no one is touching the touch area, unplug and re-plug
in the blender� If the problem persists please contact your Blendtec Service Agent�
Overtemp Error — This indicates that the motor is overheating� The blender has
been disabled until the unit cools to operating temperatures� If the blender does
not work after 20 minutes or more of cooling time, please call your Blendtec
Service Agent�
Overload Error — This indicates an overload on the motor�
1� Clear the error message by pressing any button or turning the blender off and
on again�
2� Remove the jar, and run the blender to determine whether the issue relates to
the jar or the motor�
3� With the jar removed, check for blockage in or around the socket on the motor
base and the blade assembly on the jar�
4� Place the jar securely on the motor base, and touch to pulse the blade through
the mixture�
5� Ensure the jar is not loaded with excessively hard or thick ingredients�
If overload condition re-occurs, contact your Blendtec service agent�
Reset Errors — If the following error messages appear, reset the error by
pressing the cancel button or cycle the power by unplugging your blender
and then plugging it back in� If the error does not clear, contact your
Blendtec service agent�
• Error: Overtemp� condition detected
• Error: Overload condition detected
• Error: Temp� sensor not detected
• Error: Zero crossing not detected
• Error: Reset error detected
• Error: Read / Write error detected
• Error: Motor control error detected
• Error: Invalid blend cycle
• Error: Touch controller not detected
47