Ecco C2013B Instrucciones De Instalación Y Funcionamiento página 2

Ocultar thumbs Ver también para C2013B:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation, Wiring and Function
Installation:
Camera Model C2013B
Important! Mount the camera at a location that provides the best view of the area immediately behind the vehicle. Generally, mounting
locations toward the top of the vehicle provide the best field of view. Lower mounting locations reduce the field of view and increase the
likelihood of damage from road spray.
1. Find an appropriate location for installation.
2. Drill holes according to the size of U-bracket and fix the U-bracket.
3. Drill a 3/4" (19mm) hole next to U-bracket.
4. Install the camera on U-bracket.
5. Connect the camera tail with the extension cable from inside the vehicle.
6. Loosen the screws on the side of the camera and adjust the camera's position to get the best view angle in the monitor.
Wiring:
Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with insulation tape. Wrap tape
tightly, overlapping by one-half widths so there are no gaps.
Figure 1
Picture depicted is for reference only.
AV1 input
AV2 input (V2)
Trigger Wire (Green) for AV2 only
GND (Black)
DC12V (Red)
Figure 2
Page 2 of 5

Publicidad

Tabla de contenido
loading

Productos relacionados para Ecco C2013B

Este manual también es adecuado para:

M7000b

Tabla de contenido