Safety Instructions; Installation Procedure - CONDENS8 CP8 Manual De Operaciones

5. Safety Instructions

Before carrying out any opera�on on the pump, make sure the power is disconnected.
The pump has been evaluated for use with water only.
Risk of electronic shock. This pump has not been inves�gated for use in swimming pool or
marine areas.
If the cord is damaged, it must be replaced with a special cord or assembly available from the
manufacturer or it's service agent.
Do not run this pump dry.
Always ensure the metal magnet in the float is facing upward. Always ensure the reservoir is
si�ng flat and horizontal.
Acceptable for indoor use only.
Non-submersible pump.
6. Preventing Siphoning

7. Installation Procedure

(1) Ensure float is posi�oned in reservoir with magnet uppermost, the filler is in place and the
lid is clipped firmly onto reservoir.
1. False ceiling
2. End of discharge tube
3. Water level in drain tray
4. Air break
5. Top of breather tube
4