Installation Instructions; Clearances And Dimensions - Cafe CWL112P2RS1 Guía Rápida

Installation Instructions

WARNING
Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause
damage to the Drawer Microwave.
• Do not use the Drawer Microwave as a storage space. This creates a potentially hazardous situation.
• Check that the time-of-day is in the display. If not, touch Stop/Clear to prevent unintended use.
UNPACK DRAWER MICROWAVE
Remove all packing materials from inside the Drawer Microwave.
DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the top of the Drawer Microwave.
Remove the feature sticker, if there is one. Check the drawer for any damage, such as misaligned or bent drawer,
damaged drawer seals and sealing surfaces, broken or loose Drawer Microwave guides and dents inside the
cavity or on the front side of the drawer. If there is any damage, do not operate the Drawer Microwave and contact
your dealer.

CLEARANCES AND DIMENSIONS

• Dimensions that are shown in Figure 1 must be used for Standard Installation. Given dimensions provide minimum
clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. See Figure 4.
• Contact surface must be solid and level. Pay special attention to the floor on which the Drawer Microwave will sit.
The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about
100 pounds).
• Check location where the Drawer Microwave will be installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself or under a gas, under an electric wall oven, or under selected
cook top models.
• Be sure that the clearance of the floor between the wall oven and the drawer microwave is a minimum of 2-inches.
• The microwave interior will easily accommodate a 9" x 13" oblong dish or a bag of microwave popcorn.
• The oven can also be mounted flush. Please see instructions for flush mounting included with the Flush Mount
Deflector vent.
2
Sealing Surface
Waveguide Cover
Sealing Surface
Oven Cavity
31-7000166 Rev. 0