Adjusting The Cutting Height; Storage; Readjusting The Cutting Mechanism - Batavia BT-CLM001 Manual De Usuario

English
Starting the cylinder mower
7.1
DANGER!
Blade cylinder continues to turn after
switching off.
Never lift, tilt or carry the cylinder mower
with the motor running!
Never start the mower on a paved surface
(e. g. asphalt).
Always maintain the safety distance
between the blade cylinder and the user set
by the guide handle.
Switch cylinder lawnmower on
7.2
(See Fig. A, J, K, L, N, O).
Note: The cylinder lawnmower is prevented
against being switched on unintentionally
by means of the safety key.
a. Place the cylinder lawnmower on a level
lawn surface.
b. Open the battery cover (5).
c. Insert the battery pack.
d. Insert safety key (12).
e. Press and hold safety lock (2) and then
pull the start bar (3) on the upper
handle.
f. Release safety lock (2).
Switch cylinder lawnmower off:
7.3
a. Release start bar (3) on upper handle.
b. Remove safety key (12) every time work
is interrupted.
Note: The cylinder lawnmower can be
operated by battery or as a manual
lawnmower without battery power.

Adjusting the cutting height

7.4
Danger! Cutting tool can cause injuries!
When adjusting the cutting height, remove
the key and wear suitable work gloves.
The cutting height can be set to four
positions between 13 mm and 38 mm.
(See Fig. Q, R, P).
a. Pull the length adjustment knob (8)
toward outside direction, then
clockwise or anti-clockwise.
b. Insert the length adjustment knob (8)
into the location hole of support plate
according to the desired cutting height.
c. The cutting height is shown on the
height dial.
8
The length adjustment knob (8) must
always be set to the same height on both
sides.
The mower may only be adjusted to a depth
in which the lower blade does not touch the
ground when the surface is uneven.
Mowing with the grass catcher
7.5
a. Assemble both metal frames into each
other (See Fig. D).
b. Pull the catch bag over the metal frame
(See Fig. E).
c. Insert the locker into the shaft of rear
wheel (See Fig. F, G).
d. Also you can insert the locker into the
holder of main housing, if you want the
cuttings directed to the ground
(See Fig. H, I).

8. Storage

The storage location must be inaccessible
to children.
• Remove safety key.
• Charge the battery.
• Clean mower before storage.
• Store mower in a dry place.
To save space, the cylinder mower can be
folded up by folding the clamping lever.
Ensure the cable is not trapped during this
process.
9. Readjusting the cutting
mechanism
(See Fig. M).
The cutting gear of your lawnmower was
optimally adjusted before leaving our
company. If, after use, a clean cut of the
grass is no longer possible or the blade
roller contacts the lower blade, then the
lower blade should be adjusted as follows:
a. Unhook the handle (1) and clean
cylinder mower.
b. Check cylinder mowing blade (11) and
lower counter blade (10) for notches
and remove these with a grindstone if
necessary.
c. Unscrew left and right allen screws (13)
with an allen wrench (5 mm)
anticlockwise until the cylinder mowing
blade (11) turns freely.