Active Era WS-01BU-UK Manual De Instrucciones página 10

Inflation
• Find a smooth, flat and clean surface with plenty of room to
unfold your board. Lay it, unfolded, with the valve facing up and
the two small fins facing down.
• Connect the pump to the hose on the "INFLATE" Hose Adapter
(labelled on the top of the pump). (1)
• Unscrew the valve cap.
• Put the button in the "UP" position. (2)
NOTE: when inflating or deflating your paddleboard, push (a) and
twist (b) the valve button to open or close the valve.
• Insert valve side connector into valve and secure by turning
clockwise. (3)
• Pump until you reach the required pressure. We recommend
starting with Dual Action Mode and changing to Single Action
Mode as the pumping becomes difficult.
WARNING: The correct range for this board is 7.5 - 15PSI
(0.5-1bar). Do not exceed the maximum recommended pressure.
• Remove connector and replace valve cap when using the board (4)
1
INFLATE
3
NOTE: The board should feel solid when fully inflated. Please do
not apply sustained pressure to the board when on land as this may
damage the small fins.
10 | English
2
a
b
4