With your new washable Lady shaver appliance you can remove
unwanted hair easily, quickly and conveniently.
It works on two R6 1, 5 Volt "penlight" alkaline batteries model
(not included).
Note: alkaline batteries contain substances which may pollute the
environment.
Please, dispose of your old batteries at an officially assigned place.
Important
- Before using the appliance, read the user manual carefully and
refer to the illustrations.
- Regular cleaning and good maintenance ensures optimum results
and guarantees the longest lifetime for the Lady Shaver
- Ensure that your hands and the appliance are dry when
inserting the batteries.
- To keep your Lady Shaver water-proof :
- Keep the rubber sealing ring of the battery compartment clean
and undamaged.
- From time to time apply some Vaseline to the rubber sealing ring.
- To avoid damage due to battery leakage :
- Remove the batteries if you do not intend to use the appliance
for a month or longer.
- Do not leave exhausted batteries in the appliance
- The product must not be immersed
General description ( fig.1)
- Protective Cap. Please, keep the protective cap on your Lady
Shaver when not in use.
The protective cap prevents the shaving foil and two trimmers from
being damaged.
B - Shaving head. The shaving head is equipped with two trim-
mers (( C ) and (E)) and a shaving foil (D).
C - Straight trimmer. Designed to remove longer hairs from arms,
legs and bikini area.
D - Shaving foil. With the shaving foil you remove the shorter hairs.
E - Curved trimmer. Specially designed to shave under arms.
F - ON / OFF switch (slide).
I - on, O -off
G. Battery compartment
H. Cover of battery compartment.
How insert the batteries.
- Switch off the appliance.
- Remove the battery compartment cover (H) by pulling it in the
direction of the arrow.(Fig.2)
- Insert two 1, 5 Volt alkaline penlight batteries exactly as it shown
in the picture (Fig.3). Please, note the diagrams moulded into the
battery housing.
- Replace the cover by pushing it on to the appliance. ("Click!")
How to use your Lady Shaver
On wet skin.
You can use your Lady Shaver on wet skin, e.g. while having a
bath or a shower.
The product can be used under a shower and after the bath.
The best results are obtained if you lather your skin (with soap or
shaving cream) before use (Fig.4)
On dry skin.
If you prefer to use the shaver dry, please ensure that your skin
is clean and absolutely dry.
- Handling the appliance on wet or dry skin is the same.
- Do not apply alcohol based lotions directly before or after use.
- However, talcum powder can be used.
- void pressing the shaving head too hard against the skin as
this will adversely affect the shaving performance and may cause
some skin irritation.
rms and legs.
- Switch on by sliding switch (F) to position 1 ( Fig.5)
- Stretch the skin taut with your free hand so that the hairs stand up.
- Place the straight trimmer (C) and the shaving foil (D) gently on
the skin.
- Move the Lady Shaver slowly and with the light pressure against
the direction of the hairs growth ( Fig.7)
- Switch off the appliance after use by sliding switch (F) to
position O (Fig.8).
Under arms
- Switch on by sliding switch (F) to position 1 ( Fig.5)
- Stretch the skin by raising the arm high.
- Place the rounded trimmer (E) and the shaving foil (D) gently on
the skin.
- Move the Lady Shaver slowly and with the light pressure over
the skin.
- You can best find out for yourself how to move the Lady Shaver :
up and down or with lateral movements. ( Fig.7)
- Switch off the appliance after use by sliding switch (F) to
position O (Fig.8).
Cleaning
- Ensure that the appliance is switched off when cleaning.
-
void the brush touching the shaver foil as this may cause
damage.
- Do not apply any pressure on the shaving foil
- Do not clean, rinse or immerse in water if the battery
6
GB