OPERATION PROBLEMS AND THEIR SOLUTIONS (TROUBLESHOOTING)
What if ...
The appliance is plugged in to the mains but it does not work and the
electricity supply voltage indicator is not illuminated. Check that your house
electricity supply installations are in order. Check that the plug is correctly inserted
into the electricity supply socket.
The noise has become louder. Check that the appliance is standing stable on a
level place. To make it level, regulate the front feet. Check if the appliance is not
touching any furniture and that no part of the refrigeration system at the back part of
the appliance body is touching the wall. Pull the appliance away from any furniture or
walls. Check that the cause of increased noise isn't due to bottles, cans or dishes in
the appliance that might be touching each other.
When the appliance door is opened, the rubber sealing gasket pulls out. The
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
The temperature rise indicator light is illuminated red.
appliance is being connected to the electricity supply for the first time or it was
disconnected for a significant period (for thawing or during an interruption to the
electricity supply), the freezer door is not closed or is being frequently opened and
closed, or a large amount of fresh food has been put in, and therefore the
temperature in the compartment has risen above -9 ºC. When the temperature in the
compartment
again
ATTENTION! If the temperature indicator light does not go out (for reasons
other than those listed above) for longer than six hours, the compressor is
either working constantly or is not functioning. You need to consult service
people.
High temperature in appliance, the compressor operation pauses are short.
Ascertain whether the appliance door are shutting tightly, whether the door wasn't
kept open longer than necessary when taking out or putting in foodstuffs or whether a
large amount of warm food was placed in the appliance.
The top of the appliance has condensation on it. The ambient relative air
humidity is above 70 %.
possible remove the cause of the humidity.
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE INSTRUCTIONS
FOR TRANSPORTATION.
The appliance should be transported in the vertical position.
When being transported, the appliance should be protected from atmospheric
conditions (rain, snow, dampness).
The appliance should be firmly secured in place while being transported, to avoid
slippage or any shocks in the transport vehicle.
If the appliance was transported not vertically, it may be connected to the
mains after 4 hours at least. If this is not done, the appliance compressor
may fail.
All manuals and user guides at all-guides.com
falls
below
Ventilate the room where the appliance stands and if
TRANSPORT
ºC,
the
indicator
-9
32
This means the
light
will
go
out.