Tabla de contenido
Publicidad
12
SYSTEM 35
Modules
Your System 35 has two rows of modules
(1) (2) (3) (4) (5) (6)
(7)
Top Row
(1) & (4)
921A Oscillator Driver.
(2) & (3) / (5) & (6)
921B Voltage Controlled Oscillators (VCO).
(7) 921 Voltage Controlled Oscillator (VCO/LFO)
(8) 914 Fixed Filter Bank (FFB).
(9) 923 Filters and Noise Sources.
(10) 904B High Pass Filter (HPF).
(11) 904A Low Pass Filter (LPF).
(12) 992 Control Voltages.
(13) CM1A – MIDI interface.
Bottom Row
(1)
(2)
(3)
(4)
(5)
(1) & (3)
CP3A – O
(2) & (4)
CP3A – M
(5) CP35 Attenuator / Voltage Source / Multiple
(6) 961 Interface.
(7) - (9)
911 Envelope Generators (EG).
(10) - (12) 902 Voltage Controlled Amplifiers (VCA).
Further information on all modules can be found on their individual Quick Start Guides at www.behringer.com/downloads.html
(8)
(9) (10) (11) (12)
(13)
(6)
(7) (8) (9) (10) (11) (12)
System 35 - Getting Started
CONNECTION
To connect the System 35 to your system, please refer to the individual patches.
HARDWARE SETUP
Make all the connections in your system. Keep the System 35 power turned off when making any connections.
Ensure your sound system is turned down.
Turn on the System 35 before turning on any power amplifiers and turn it off last. This will help prevent any turn on or turn off "pops or thumps" in your speakers.
WARM UP TIME
We recommend leaving 30 minutes or more time for the System 35 to warm up before recording or live performance. (Longer if it has been brought in from the cold.)
This will allow the precision circuits time to reach their normal operating temperature and tuned performance.
System 35 Patches
Expressive Lead #1
Voltage Control (pitch)
Source
Destination
External MIDI Keyboard – MIDI Out
CM1A MIDI Interface MIDI In
CM1A CV Output
921A Oscillator Controller Frequency Input
921A Frequency Output
921B Frequency Link (in series)
Audio
921B Waveform outs (three of four)
CP3A-M Inputs
CP3A-M Output
904A Signal Input
904A Signal Output
902 Signal Input
902 Signal Output
Your mixer/amplifier/DAW
Voltage Control (amplitude)
CM1A s-trigger Output
Multiple
Multiple Output (three of)
3 x 911 s-trigger Input
1st 911 Output
1st 902 Control Input
13
Quick Start Guide
To mixer/ampli er/DAW
MIDI Out
Publicidad
Tabla de contenido
