How To Operate - Work Pro W L 16 DMX Manual De Uso

How to operate?

L 16 DMX
1.
When switching on the power supply, the LED window will display the start DMX channel
address. It can be "A001". If there are no character and number display, check the power
whether it's correctly connected.
2
. The default start address for controlling the DMX channels is channel 1. To adjust the initial
start address, you can press the Up key to increase it by 1. When holding the Up key for 1
second, the start address will increase rapidly from the initial value to the desired value. You
.
can also press the Down key to decrease the present value by 1. When holding the Down key
for 1 second, the present value will decrease rapidly to the desired value.
NOTE: Whenever you want to adjust the start address, press Up key or Down key to shift the
start address setting mode. In this case, you may change the start address temporarily . You
can control the 16 continual DMX channels from the beginning of the starting address. The start
address must be 1 ~ 512. And the overflowing channels will not be proceeded.
3.
Pushing the channel fader, one of the 16 channels faders, can allow you to adjust the relative
channel value. The LED will display the value temporarily with the default mode of decimal
( 0 ~ 255 ) when sliding the fader. For percent display mode, you can press the MODE key.
In this case, the indicating LED of right lower corner will be out in the display window and
the indicating LED of right higher corner will be lit up.
After you have set the 16 channels values, waiting about 10 seconds, the LED window will
automatically show the start address.
L16 DMX
Fader
User Manual /Manual de Uso
SERIES 2
Mode Down Master
Up
Fader
EN
2