How To Use The Product - Lionelo Otto Manual Del Usuario

3.
Lift frames of the seat (5) and then put the fabric covering on it (fig. 3). Fasten the
Velcro at the bottom of the covering.
How to replace a battery
1.
Use a screwdriver to loosen the bolt which secures the battery compartment
(fig. 4).
2.
Remove the battery cover and insert four LR14 batteries in the
compartment. Pay special attention to battery poles (see: fig. 5).
It is advisable to use alkaline batteries.
3.
Put the battery cover on and tighten up with a screwdriver. Do not tighten
up too firmly (fig. 6).
Feeder cable
To use the mains power supply, connect a USB cable to the sound module of
the baby swing (port marked as e in fig. 13). Insert the second tip in the relevant
mains power adapter (not supplied).
Note! The feeder cable should have the following parameters:
input: 100-240V ~ 50/60Hz 0.3A, output: 5V

How to use the product

Cushion – the product is equipped with a high-quality cushion which can be
attached to the covering with a Velcro (6) located underneath the cushion. To
do so, pull the cushion Velcro through a fastening which stands out from the
seat (fig. 7) and fasten it.
5 – point safety belts - when the child is in the baby swing, safety belts must
always be fastened.
A.
To fasten the belts:
1.
Put the child into the baby swing. Make sure your child's legs go through
the protective fabric cushion, as presented in fig. 11.
2.
Insert the tip of shoulder belts (A in fig. 8) in hip belts (B in fig. 8). Pull child's
hands through them.
3.
When the belts are connected, insert them in the buckle (C in fig. 8). If you can
hear a „click", it means the assembly has been successful.
4.
After you have fastened the belts, put the protection on the buckle (fig. 9).
1000mA.
‑ 7 ‑ EN