Troubleshooting - Lionelo Otto Manual Del Usuario

2.
Disconnect the control module from the baby swing. frame and then lift it.
3.
Connect the legs of the product.
4.
Secure the product with an assembly belt located at the reverse of the
covering (see: fig. 15)

Troubleshooting

Problem
Light indicator
flashes
Rocking stops
suddenly.
Rocking does
not start
The angle of
rocking is lower
than desired.
Distorted music.
Possible cause
Low batteries
or damage to
feeder cable.
Set time has
passed.
Batteries have
been inserted in
a wrong way.
Damage to the
feeder cable.
Feeder cable
has been connected
in a wrong way.
No power supply
in the socket.
The baby swing
needs about
20-45 seconds
to rock properly.
Flat batteries.
Solution
Replace battery or
adapter.
Deactivate rocking
with a knob and
then activate it
again. Disable
rocking time setting.
Insert the batteries
again. Pay special
attention to marking
(poles).
Check the feeder
cable and wire for
proper connection.
Check if the feeder
cable has been
plugged in the
socket properly.
Replace the batteries.
‑ 9 ‑
Additional information
Each of these solutions
will cause the product to
resume working, only the
following will change: work
time and rocking speed.
At low voltage and high
load, the baby swing may
need up to 50 seconds to
start rocking properly.
EN