VONROC PM506DC Traducción Del Manual Original página 9

Removing the whisk
1. Loosen the assembled whisk using the supplied
spanners (10). To do so, hold the tool holder (4)
using one of the supplied spanners (10), and
use the second spanner to loosen the assemb-
led whisk.
2. Unscrew the whisk from the tool holder (4) in
anti-clockwise direction.
4. OPERATION
Switching on and off (Fig. B)
The on/off switch (7) is used for activating the
machine and adjusting speed.
• To start the machine, press and hold the lock off
button (8) and press the on/off switch (7).
• To stop the machine, release the on/off switch (7).
Speed adjustment (Fig. B)
The required speed can be adjusted by using the
Speed adjustment wheel (9). Also during operation
the rotational speed can be adjusted.
• To increase the speed, turn the Speed adjustment
knob (9) clockwise.
• To decrease the speed, turn the Speed adjustment
knob (9) anti-clockwise.
The required speeds depends on the material and
can be determined by practical testing.
Optimum use
• For materials with low viscosity, e.g. emulsion
paint, varnishes, adhesive, grouting compound
and cement slurry, a stirrer whisk with a so-cal-
led left-hand spiral is recommended for opti-
mum use. With a left-hand spiral, the material is
moved from the top downwards and the stirrer
whisk is pushed upwards. Materials with low
viscosity are mixed in a way which minimises
splattering, so a low speed is recommended.
• For materials with high viscosity, e.g. plaster,
concrete, cement, screed, filler and epoxy resin,
a stirrer whisk with a so-called right-hand spiral
is recommended for optimum use. With a right-
-hand spiral, the material is moved from the
bottom upwards and the stirrer whisk is pulled
downwards (working its way into the mixture).
Materials with high viscosity are mixed thoroug-
hly, so a high speed is recommended.
• For optimum results, move the power tool in an
up and down motion while mixing.
• It is recommended to clean the whisk after use,
WWW.VONROC.COM
for example by stirring the whisk in a bucket
filled with water.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings (3) are free of dust and dirt.
Remove very persistent dirt using a soft cloth moi-
stened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
EN
9