Machine Information - VONROC PM506DC Traducción Del Manual Original

EN
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY INSTRUCTIONS
• Hold the tool with both hands at the intended
handles. Loss of control can cause personal
injury.
• Ensure sufficient ventilation when mixing flam­
mable materials to avoid a hazardous atmosp­
here. Developing vapour may be inhaled or be
ignited by the sparks the power tool produces.
• Do not mix food. Power tools and their accesso-
ries are not designed for processing food.
• Keep the cord away from the working area. The
cord may be entangled by the mixer basket.
• Ensure that the mixing container is placed in a
firm and secure position. A container that is not
properly secured may move unexpectedly.
• Ensure that no liquid splashes against the
housing of the power tool. Liquid that has pe-
netrated the power tool can cause damage and
lead to electric shock.
• Follow the instructions and warnings for the
material to be mixed. Material to be mixed may
be harmful.
• If the power tool falls into the material to be
mixed, unplug the tool immediately and have
the power tool checked by a qualified repair
person. Reaching into the bucket with the tool
still plugged in can lead to electric shock.
• Do not reach into the mixing container with
your hands or insert any other objects into it
while mixing. Contact with the mixer basket
may lead to serious personal injury.
• Start up and run down the tool in the mixing
container only. The mixer basket may bend or
spin in an uncontrolled manner.
SAFETY WARNINGS FOR BATTERY
a) Do not open the battery. Danger of shortcircuiting.
b) Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
c) In case of damage and improper use of the bat­
tery, vapours may be emitted. Ventilate the area
and seek medical help in case of complaints.
6
The vapours can irritate the respiratory system.
d) Use the battery only in conjunction with your
Vonroc product. This measure alone protects
the battery against dangerous overload.
e) The battery can be damaged by pointed objects
such as nails or screwdrivers or by force applied
externally. An internal short circuit can occur and
the battery can burn, smoke, explode or overheat.
SAFETY WARNINGS FOR CHARGER
Intended use
Charge only CD801AA and CD803AA type rechar-
geable Battery packs with the charger. Other types
of batteries may burst causing personal injury and
damage.
a) The appliance is not to be used by persons
(including children) with reduced physical, sen­
sory or mental capabilities, or lack of experien­
ce and knowledge, unless they have been given
supervision or instruction.
b) Children being supervised not to play with the
appliance.
c) Do not recharging non­rechargeable batteries!
d) During charging, batteries must be placed in
the well ventilated area!
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or the
mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The machine is intended for mixing pulverised buil-
ding materials such as mortar, plaster, adhesives,
as well as solvent free paint, varnish and similar
substances. Improper use may damage the tool.
TECHNICAL SPECIFICATIONS
This manual has been drawn up for
different sets / article numbers. Check the
corresponding article number in below
specifications table for the correct
composition and contents of your set.
WWW.VONROC.COM