ONFORU DT5UV Guia De Instalacion página 2

13.This product is not waterproof, please do not submerge in water or
do not use it in the humid environment for a long time.
14.Don't roll the light strip during the operation, otherwise it will melt.
15.Don't cover the light strip as the covering may cause the light strip to
overheat and melt or ignite.
16.Please use our power adapter, controller or dimmer, the power of
the strip light cannot be higher than the maximum power of the
adapter, controller or dimmer.
17.Only use the provided hanger or clip to protect the light strip. Do not
use staplers, nails or similar things to fix this product or its wires, which
may damage the insulation.
18.Risk of fire - do not replace the plug. The plug contains a safety
device (fuse) that should not be removed. Discard product if the
plug is damaged.
NOTE
01
01 Safety Class III = Only operate lamps with this symbol with
-
Safety Extra Low Voltage (SELV). Only connect to SELV circuits.
02 - Lights that are not suitable for covering with thermal insulation materials.
03 - Lights that are not suitable for being directly installed on normally
flammable surfaces.(only suitable for being installed on a non-flammable
surface)
04 - It is not suitable for household room illumination.
05 - Safety Class II=This lamp is doubly insulated and may not be wired to a
protective conductor.
Please install the lights on the dust-free, clean and smooth
surface, otherwise the strips will fall.
During the installation, the bend should be avoided to be just in
the position of LEDs or other components.
02 03 04
2
English
05