Operating Instructions - BE Power Equipment P2115EN Manual Del Operador

ASSEMBLY INSTRUCTIONS
11
G

OPERATING INSTRUCTIONS

• Make sure the "ON/OFF" switch is in the "OFF" position. The
power switch has international symbols for 'on' and 'off': On
(|) Off (O).
• Unwind the power cord completely and plug the GFCI (For
US unit only) into a grounded 120 volt outlet.
• Turn on water supply at the faucet to completely
open.
• Release safety push trigger lock up and back into trigger.
While pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady stream of
water, letting the water and air out of the hose. Push trigger
lock back down to lock back into place.
OFF/0
ON/I
10
OFF/0
ON/I
Attach garden hose to the garden hose adapter (G).
Flush out garden hose before connecting
Note:
to garden hose adapter.
• Turn the power switch to the "ON" (|) position. The unit will turn
on for 1 - 2 seconds and shut off. This is a normal function of
the auto start feature. Squeeze the spray gun trigger to begin
pressure washing.
• Begin power washing by squeezing the trigger on the spray gun
all the way into the handle.
• Release the spray gun trigger to stop the power washer.
• Allow the motor to come to a complete stop before squeezing
the trigger again.
• Squeezing rapidly will cause the auto start feature to miss an
on/off cycle that may prevent it from turning on while squeezing
trigger after rapid squeezing. Use slow deliberate trigger pulls to
avoid such symptoms.
• Always test a small area to avoid chance of damaging the
surface.
bepowerequipment.com