BE Power Equipment P2115EN Manual Del Operador página 11

OPERATING INSTRUCTIONS
Attach Foam Canon (stored in rear of pressure washer) into end
of lance by pressing cannon into place.It will make a "click" sound
when firmly in place.
Note: Always lock spray gun when changing the foam cannon to
ensure it does not eject with force.
• When using the foam cannon, fill it with a properly formulated
detergent or cleaner with water ratio according to instructions
on the container.
• DO NOT use thick gel-like detergents as they will clog the foam
cannon and can cause damage.
• The power washer will pull a ratio of water to detergent of 10:1 or
10 parts water to 1 part detergent. The detergent concentration
can be adjusted by turning the detergent knob on the top of the
cannon. Turn it left for more concentration or turn it right for less
concentration.
Operation Tips
• Note: Test the GFCI (For US unit only) before each use:
1. Plug GFCI into power outlet. Indicator should turn green to
show that cord has power.
2. Press test button, green indicator should turn off to verify
that GFCI cut off power to the cord.
3. Press reset button – green indicator should turn on to
show that cord has power again.
4. When GFCI is working properly, green indicator will turn
on when power is applied. If green indicator turns off, it has
detected electric leakage and the GFCI cut off power to
theappliance.
bepowerequipment.com
1
3 3
• If you hear the motor run intermittently when the trigger is not
being squeezed, that is normal.
The pump is priming itself so it is ready to operate when the
trigger is squeezed. Turn off the power washer if not being
used after five minutes.
• The o-rings on the bayonet end of the nozzle lance should be
cleaned regularly and lubricated with non-water soluble grease
such as petroleum jelly.
• Keep the nozzle cleaning wire for use in unclogging the nozzle.
If you lose the cleaning wire, astraightened paper clip also
works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because the impact
force of the water pressure exceeds the durability of the
surface. Bare wood can be penetrated; paint can be peeled
off, etc. You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
• NEVER use a narrow high pressure stream of water on soft
surfaces susceptible to damage.
• Use the 25° quick connect nozzle when cleaning windows.
Squeeze the trigger and vary the spray pattern and angle until
optimum cleaning efficiency is achieved.
Using Power Cord
• Easily remove the power cord from side of unit by swiveling the
bottom red cord hook to the right or left until it faces up. The
power cord then can be easily slid off of the side of the power
washer unit.
• Swivel red cord hook back down when ready to wrap the cord
back into place for storage.
11