Transportation, Storage And Disposal; Technical Data - Husqvarna CL400i Manual Del Usuario

Introduction
WARNING:
start during transport pull up the safety
key, remove the battery and wait at least 5
seconds.
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
• Put tape on the battery connectors and make
sure that the battery cannot move around during
transport.
• Attach the product during transport.
Storage
• Before storage, let the product become cool.
• Always remove the battery for storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
• Keep the battery charger in a closed and dry space.
• Keep the battery and the battery charger in a dry
space where there is no moisture or frost.
• Disconnect the battery from the battery charger
during storage.
• Do not keep the battery where static electricity can
occur. Do not keep the battery in a metal box.
Drilling motor
Motor type
Motor speed – nominal, rpm
Motor speed – high load, rpm
Motor output – maximum, kW
Motor output – nominal, kW
Transmission
Clutch
Weight
1698 - 001 - 21.01.2022

Transportation, storage and disposal

To prevent unintentional

Technical data

• Keep the product where the ambient temperature is
between -10°C and 40°C.
• Keep the battery where the ambient temperature is
between 5°C and 25°C and out of sunlight.
• Keep the battery charger where the ambient
temperature is between 5°C and 45°C and out of
sunlight.
• Make sure that the battery is charged to 30% - 50%
before you put it in storage for long periods.
• Keep the product, battery and battery charger in
a locked area out of reach for children and not
approved persons.
• Clean the product.
• Do the maintenance procedures given in this
operator's manual. Refer to
on page 17 .
• Do a complete servicing before you put the product
in storage for a long time.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise
result through the incorrect waste management of this
product. For more detailed information about recycling
this product, contact your municipality, your domestic
waste service or the shop from where you purchased
the product.
(Fig. 58)
BLDC (brushless) 36V
3000/min
3300/min
1.8
1.2
Mechanical gearbox with oil bath gears
Belt-type, with pulley
Maintenance schedule
21