Beacon Lighting LUCCI AIRFUSION FLUSSO Manual De Instrucciones página 8

Airfusion Flusso Installation Instructions
BLADE ATTACHMENT (Fig.10)
1. Remove the 3 blade screws from the fan motor (Fig. 10a), and insert the blade mounting end into the slot
of the rotating drum (Fig. 10b).
2. Align the 3 holes on the blade with the 3 holes on the rotating drum of fan motor assembly and using
the 3 blade screws, to secure the blade to the fan motor assembly. Ensure all screws are tightened
evenly to reduce the chance of warping or unbalancing. Take care not to over tighten the screws, as
this can damage the blades (Fig. 10c).
3. Once completed, repeat the process on the remaining blades.
Fig. 10a
NOTE : Don't run the motor without blades installed!
INSTALLING THE LED LIGHT KIT ( FIG.11)
NOTE: To avoid possible electrical shock, be sure you have turned off the power at the main circuit panel
Connect the wires of light kit to the fan assembly via the quick connector.
⚫
Install the light kit on the fan assembly then secure it by turning clockwise.
⚫
7 | P a g e
INSTALLING THE FAN BLADE AND LIGHT KIT
Fig. 10b
Fig. 10c
Fig. 11
V 1 . 0 ( 0 7 / 2 0 2 1 )